ES-2000HT INTL Installation & Operation Manual 7610-003-24-90
Issued: 07-10-2006 Revised: N/A
SECTION 6: PARTS SECTION
SOLENOID VALVE
30
Screw
Data Plate
Solenoid Valve 110 Volt Coil and Housing
Part number 06401-003-07-43
Solenoid Valve 230 Volt Coil and Housing
Part number 06401-003-07-44
Solenoid Valve Plunger Kit
Includes plunger and spring
Part number 06401-003-07-40
Valve Bonnet
Diaphragm
Retainer
Diaphragm
O-Ring
Plunger
Spring
Screen
Retainer
Mesh Screen
Valve Body
Complete Solenoid Valve
Part number 04810-100-12-18 (1/2”, 110 Volt)
Part number 04810-100-09-18 (1/2”, 230 Volt)
Part number 04810-100-53-00 (3/4”, 110 Volt)
Part number 04810-100-03-18 (3/4”, 230 Volt)
TO DISASSEMBLE - These valves may be taken apart by
unscrewing the bonnet and the enclosing tube assembly from the
valve body assembly. After unscrewing, carefully lift off the bonnet
and enclosing tube assembly. Don’t drop the plunger. The o-ring
seal and diaphragm cartridge can now be lifted out. Be careful not
to damage the machined faces while the valve is apart.
TO REASSEMBLE - Place the diaphragm cartridge in the body
with the pilot port extension UP. Hold the plunger with the synthet-
ic seat against the pilot port. Make sure the o-ring is in place, then
lower the bonnet and enclosing tube assembly over the plunger.
Screw the bonnet assembly snugly down on the body assembly.
Pilot port extension
#1 clogged. Clean
hole.
Possible Problems:
Hole #2
Clogged.
Pass heated
straight pin
through hole.
Solenoid Valve Diaphragm Kit
Includes diaphragm and o-ring
Part number 06401-003-07-41 (1/2” NPT)
Part number 06401-003-07-42 (3/4” NPT)
To Next Page
Loading...