32
English (EN)
5.5. Water connection
•
pipe, the supply line should be rinsed thoroughly
in order to remove impurities.
•
•
12.2.
• Minimum diameter of the supply pipe must be at
•
•
• Avoid long pipe lines.
•
• Avoid fittings with high pressure loss.
6. System preparation
6.1. Start up of new system
these guidelines.
6.2. Bleeding guidelines
6.2.1. Bleeding the pipe system
•
• Leaving the air supply open may allow air to enter
the water pipe.
•
longed shutdowns.
6.2.2. Bleeding the pump
•
to the top of the pump.
• Stop the pump.
•
until only water flows.
• Tighten the relief plug.
•
operation as this may damage the gasket.
A
• The mainstation is now ready for use.
6.3. Adjustments
6.3.1. Instruction and setup
110005283
110009489
To Next Page
Loading...
