5
EcoLet cross section
Settings
Capacity settings
Adjust capacity by turning the dial.
The recommended start setting for 2 people:
Green light: Only fan is operating (see Heater settings, Step 1 below).
After 1 week in operation, you might have to adjust the setting depending on usage and the
liquid level in the tube (#28).
Heater settings
Set the heat according to load, read the level tube (#28) on the right side (seen from the front).
• Step 1 Green light: Only fan is operating
• Step 2 One amber light: Fan + 50% top heater
• Step 3 Two amber lights: Fan + 50% top heater + 100% bottom heater
• Step 4 Three amber lights: Fan + 100% top heater + 100% bottom heater
1
2 3 4
To Next Page
Loading...