Ecolink Z-Wave Plus Smart User Manual

© 2018 Ecolink Intelligent Technology Inc. PN STLS2-ZWAVE5
Network Inclusion
The Z-Wave Plus Smart Switch must be added to a Z-Wave Plus
network prior to use. To include the device in a network both the
device and the network controller must be in inclusion mode at the
same time. Refer to the instructions provided by the manufacturer of
your specific controller for details on initiating the controller’s
inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible
with the Z-Wave Plus Smart Switch.
2) Put your Z-Wave Plus Controller into add (inclusion) mode.
3) Press the inclusion / exclusion button on the Z-Wave Plus Smart
Switch.
4) The LED on the front of the unit will turn off if network inclusion is
successful.
Network Exclusion
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus
controller. Follow the directions to put your Z-Wave Plus
Controller into exclusion mode.
2) Press the inclusion / exclusion button on the Z-Wave Plus Smart
Switch.
3) The LED in front of the unit will blink steadily if the network
exclusion is successful.
*Please refer to the LED status section for more information on the
LED behavior

Ecolink Z-Wave Plus Smart Specifications

General

Brand	Ecolink
Model	Z-Wave Plus Smart
Category	Switch
Language	English