Ecolink Z-Wave Plus Smart User Manual

© 2018 Ecolink Intelligent Technology Inc. PN STLS2-ZWAVE5
Device Classes
Generic Device Class
GENERIC_TYPE_
BINARY_SWITCH
Specific Device Class
SPECIFIC_TYPE_
POWER_SWITC
H_BINARY
Command
Classes
COMMAND_CLASS_ZWAVEPLUS_INFO
v2
COMMAND_CLASS_VERSION
v2
COMMAND_CLASS_MANUFACTURER_SPEC
IFIC
v2
COMMAND_CLASS_POWERLEVEL
v1
COMMAND_CLASS_BATTERY
v1
COMMAND_CLASS_SWITCH_BINARY
v1
COMMAND_CLASS_ASSOCIATION
v2
COMMAND_CLASS_ASSOCIATION_GRP_IN
FO
v1
COMMAND_CLASS_BASIC
v1
COMMAND_CLASS_FIRMWARE_UPDATE_
MD
v2
Manufacturer
ID
0x014A
Product Type
0x00 06
Product ID
0x00 01
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class
B digital devices, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 Re-orient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment to an outlet on a different circuit from the
receiver
 Consult the dealer or an experienced radio/TV contractor for
help.
Warning: Changes or modifications not expressly approved by Ecolink
Intelligent Technology Inc. could void the user’s authority to operate the
equipment.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
C’et appareil est conforme la norme d'Industrie Canada exempts de licence
RSS. Son fonctionnement est soumis aux deux conditions suivantes: (1) c’et
appareil ne peut pas provoquer d'interférences, et (2) c’et appareil doit
accepter toute interférence, y compris les interférences qui peuvent causer
un mauvais fonctionnement de la dispositif.
FCC ID: XQC-STLS2ZWAVE5
IC: 9863B-STLS2ZWAVE5

Ecolink Z-Wave Plus Smart Specifications

General

Brand	Ecolink
Model	Z-Wave Plus Smart
Category	Switch
Language	English