eControls RT2 User Manual

Install Batteries and Set Installer Options 4)
Slide the battery cover down.
Place the batteries in the RT2,
making sure the polarity is correct.
Slide the battery cover up. The
RT2 is now ready for operation.
Homeowner - The following options have been set by the installer. Changing options without contacting
your installer could result in the fan not operating correctly or damage to the control.
!
Option Tag Factory
01
02
SPd
HSS
2
Off
Description Selections
Set WHF Speeds
High Speed Start
1, 2 or 3
Off or On
Installer - Ensure the number of fan speeds is set correctly before operating the WHF. Failure to do so
could damage the FC3J control board.
!
01 Set the Fan Speeds
Select 1, 2 or 3 Speed
Option
Next
Enter
Use the DOWN
key to select 1-
speed.
Option
Next
Enter
Use the UP key
to select 2-speed.
Option
Next
Enter
Use the UP key
to select 3-speed.
Press the NEXT key to go to the next option or press
ENTER to save the selection.
Linked
Set To
Cool
Indoors
o
F
Access the Installer Options by
pressing and holding the
MENU key for about 7 seconds
until Option 01 is displayed.
ACCESS INSTALLER OPTIONS
Outdoors
Econo
Cooling
Menu
OFF
3 3
INSTALL BATTERIES
02 High Speed Start Up
Option
Enter
Use the DOWN key to
select OFF.
Press the ENTER to save the selection.
Use the UP key to select
ON.
For some installations, a low speed start up may not be
adequate to fully open the damper. When this option is
set to ON, the WHF will start up in high speed and after
about 10 seconds will return to the low speed setting.
Option
Enter
INSTALLATION
10

eControls RT2 Specifications

General

Brand	eControls
Model	RT2
Category	Control Unit
Language	English