1413
https://www.altonindustries.com
info@altonindustries.com
Roller brush is not wet enough---Wetting the
roller brush by moving it back and forth in one
position.
>> Roller brush is too
dry
No water in the clean water tank---Fill it with
tap water.
>> Device can not suck
dirt
Clean water tank is not properly installed in the
equipment---Install the clean water tank and
make it be firmly fixed in the equipment.
Missing or incorrectly installed roller brush---
Install it correctly.
The roller brush is dirty or worn---Clean it or
replace one.
Dirty roller brush--Clean it.
>> Poor cleaning effect
Roller brush is not wet enough---Wetting the
roller brush by moving it back and forth in one
position.
There are residues of other cleaning agents on
the floor--- Residual detergent from rolling
brush can be thoroughly removed by cleaning
with water. Repeatedly clean the floor with
equipment and a clean rolling brush, thereby
removing residual detergent.
Stuck roller brush---Remove the roller brush
and check if any object is stuck in it.
>> Roller brush doesn't
work
Sewage tank is not installed in place---check
whether it is properly fixed, so take it out and
re-install.
>> Unsatisfactory water
absorbency
The roller brush is worn---replace it.
PRODUCT PARAMETERS
Product Parameters:
lnput:
Rated voltage:
Capacity:
100-240V~50/60Hz 0.4A or 0.5A
14.8V
2200mAh Lion
Output:
Rated power:
Noise:
18V DC 0.6A
40W
65dB
Packing List:
Name
Handle bar :
Brush:
Body :
Number
1
1
1
Name
Base :
Charger:
Number
1
1
To Next Page
Loading...