2. Set RF sensor channel.
3. Insert one AA battery.
4. After inserting the battery, the remote sensor
LED indicator will light for 4 seconds, and
then flash once per 60 seconds thereafter.
Each time it flashes, the sensor is transmitting
data.
5. Close the battery door.
Repeat for the additional remote
transmitters(sold separately), verifying each
remote is on a different channel.
2.4 Display Console Set Up
1. Move the remote thermometer(s) about 5 to
10’ away from the display console (if the
sensor is too close, it may not be received by
the display console).
2. Remove the battery door on the back of the
To Next Page
Loading...
