Note: The gateway can support a maximum of
8 WN34 temperature sensors. Each new sensor
will be recognized as a new channel according
to the Power-on sequence. You may attach a
label to the channel on each sensor for
distinction. The channel name can be edited
both on the app and ecowitt.net (The edited
name on the app will not sync to the
ecowitt.net website, and it should be edited on
your device setup page on ecowitt.net
separately).
If you want to use a new WN34 sensor to
replace the old one (already configured on
certain channel), please try the following:
1. Open the Sensor ID page on the WS View
app, and find your old sensor ID.
To Next Page
Loading...
