or accurately. Adjust the mounting assembly as
necessary.
Make sure you check, and correct if necessary, the
north orientation again, as the final installation step,
and now tighten the bolts with a wrench. Do not over
tighten, but make sure strong wind and/or rain cannot
move the sensor package.
4.2.3 Reset Button and Transmitter LED
In the event the sensor package is not transmitting,
reset the sensor.
Using a bent-open paperclip, press and hold the
RESET BUTTON (item 12) to affect a reset: the LED
turns on while the RESET button is depressed, and you
can now let go. The LED should then resume as normal,
flashing approximately once every 4.8 seconds.
To Next Page
Loading...
