ECOWITT WS80 - 4 Setup Guide; Install Batteries in Sensor Package

6
1. Surface tension conditioner
layer ( patent pending)
7. Mounting arm
2. Battery compartment
8. Mounting bracelet and
U-bolt set
3. Temperature & humidity
sensor
9. Power cord for built-in
heater
4. Light & UV sensor, LED
indicator
10. USB port (factory use
only )
5. Solar Panel
11.Calibration button
(factory use only )
6. NORTH alignment
indicator
12. Reset button
Table: Sensor package assembly component list
4. Setup Guide
4.1 Install batteries in sensor package
Open the battery compartment with a screwdriver and
insert 2 AA batteries in the battery compartment, and
press “Reset” button, the LED indicator on the back of
the sensor package (item 4) will turn on for 3 seconds
and then flash once every 4.8 seconds indicating sensor
data transmission. If you did not pay attention, you
may have missed the initial indication. You can always
press the reset button to start over. Make sure you see
the flash once every 4.8 seconds.