33
Using BIOS
Onboard Floppy Controller (Enabled)
Use this item to enable or disable the onboard floppy disk drive interface. The bios will automatically
detect the existence of floppy.
Serial Port1/2 Address (3F8/IRQ4/2F8/IRQ3)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a port address.
Serial Port2 Mode (Normal)
If Serial Port 2 Address is not disabled, it allows you to set the Serial Port 2 Mode.
SuperIO Configuration (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
X
CMOS Setup Utility - Copyright (c) 1985-2004, American Megatrends, Inc.
Help Item
IDE Configuration
SuperIO Configuration
mnlk
: Move F1: General Help+/-/: Value
ESC: ExitF10: Save
Enter : Select
F9: Optimized Defaults
F8:Fail-Safe DefaultsF7:Previous Values
OnBoard Floppy Controller [Enabled]
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Serial Port2 Mode [NORMAL]
Parallel Port Address [378]
Parallel Port Mode [ECP]
ECP Mode DMA Channel [DMA3]
Parallel Port IRQ [IRQ7]
Allows BIOS to
Enable or Disable
Floppy Controller
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port address.
Parallel Port Mode(ECP)
Use this item to select the parallel port mode.
ECP Mode DMA Channel (DMA3)
This item assigns a DMA channel to the parallel port. The options are 0, 1, and 3.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Press <Esc> to return to Advanced BIOS Features setting page.
To Next Page
Loading...
