53
A960M-M3 USER MANUAL
Chapter 5
Chapter 5
Setting Up AMD SB710 RAID Configuration
Setting Up a bootable RAID Array
This section explains how to configure a bootable AMD RAID array.
1. Start your computer, then press Delete to enter the BIOS setup.
The BIOS CMOS Setup Utility screen appears.
Setting Up the BIOS
2. Use the arrow keys to select Advanced menu (see Figure 1.1), then select
SATA Configuration and press Enter.
Figure 1.1 BIOS CMOS Setup Utility Main Screen
BIOS Information
System Date [Sat 03/10/2012]
System Time [00:06:22]
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Main Advanced Chipset M.I.B.III Boot Security Exit
Enter/Dbl Click : Select
+/- : Change Opt.
lk
mn
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Figure 1.2 SATA Configuration Screen
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main Advanced Chipset M.I.B.III Boot Security Exit
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Enter/Dbl Click : Select
+/- : Change Opt.
lk
mn
: Select Screen
/Click: Select Item
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
3. Use the arrow keys to select the SATA Configuration (see Figure 1.2) and
globally set SATA Configuration to RAID.
Set the date. Use Tab to
Switch between Data eletments.
SATA Configuration
Serial-ATA Controller [Enhanced]
SATA Mode [IDE Mode]
PATA Master Not Present
PATA Slave Not Present
SATA Port1 Not Present
SATA Port2 Not Present
SATA Port3 Not Present
SATA Port4 INTEL SSDSC2MH (120.0GB
To Next Page
Loading...
Need help?
General
