ECS NFORCE4-A939 - Page 39

33
Using BIOS
Press <Esc> to return to the Integrated Peripherals page.
IDE DMA transfer access (Enabled)
This item allows you to enable the transfer access of the IDE DMA then burst onto the
PCI bus and nonburstable transactions do not.
Serial-ATA 1/2 (Enabled)
This item allows you to enable or disable the onboard SATA 1/2 devices.
IDE Prefetch Mode (Enabled)
The onboard IDE drive interface supports IDE prefetching, for faster drive access. If you
install a primary and secondary add-in IDE interface, set this field to Disabled if the
interface does not support prefetching.
IDE HDD Block Mode (Enabled)
Block mode is also called block transfer, multiple commands, or multiple sector read/write.
If your IDE hard drive supports block mode, select Enabled for automatic detection of the
optimal number of block read/write per sector the drive can support.
RAID Config (Press Enter)
Scroll to this item and press <Enter> to view the following screen:

Phoenix-AwardBIOS CMOS Setup Utility
RAID Config
Press <Esc> to return to the Integrated Peripherals page.
RAID Enable (Disabled)
This item allows you to enable or disable the onboard RAID function of RAID function of
RAID supporting devices.
• IDE Primary/Secondary Master/Slave RAID (Disabled): These four items
enable or disable the IDE Primary/Secondary RAID.
• SATA 1/2 Primary/Secondary RAID (Disabled): These four items enable
or disable the SATA 1/2 Primary/Secondary RAID.

F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
Item Help

Menu Level
RAID Enable [Disabled]
IDE Primary Master RAID Disabled
IDE Primary Slave RAID Disabled
IDE Secondary Master RAID Disabled
IDE Secondary Slave RAID Disabled
SATA 1 Primary RAID Disabled
SATA 1 Secondary RAID Disabled
SATA 2 Primary RAID Disabled
SATA 2 Secondary RAID Disabled
x
x
x
x
x
x
x
x