To Next PageTo Next Page
Need help?Do you have a question about the ECU ECU-57N and is the answer not in the manual?
Details operating temperature, voltage, current, signal inputs, and timing parameters.
Illustrates front, side, and back views of the module, including mounting hole specifications.
Explains module operation in standby mode, monitoring remote start contacts for cranking initiation.
Details how remote start contacts in AUTO initiate cranking, energizing fuel and starter relays.
Describes the pause in cranking when Dip Switch 4 is OFF, with fuel applied but starter off.
Explains how reaching speed disconnect setting turns off starter relay and initiates Low Oil Pressure delay.
Details the fault when the engine fails to start within the allotted time, shutting down fuel and start relays.
Describes immediate engine shutdown when speed exceeds the Overspeed Adjustment Setting.
Explains engine shutdown due to high water temperature, requiring reset via OFF position.
Details engine shutdown after a delay if low oil pressure persists upon crank termination.
Explains stopping the engine by placing the switch in OFF, shutting down fuel relay and power.
Details clockwise turning of pots to increase settings for speed, crank, and pressure parameters.
Explains DIP switch functions for crank cycles (single/multi) and overspeed verify.
Provides precise dimensions for drilling mounting holes for the control module.
Describes the FEX3 module expanding control to 6 total engine faults, including fault combining and latch circuits.
Outlines a one-year warranty against defects in workmanship and materials, excluding consequential damages.
General