Page 8
SECNG-I-1217
800-638-3326 • edcoinc.com • techsupport@edcoinc.com
EQUIPMENT DEVELOPMENT CO., INC.
Getting Started with your New Grinder
BEGIN THE LEVELING PROCESS:
Check level of oor.
BEGIN THE LEVELING PROCESS:
Lower machine to surface and match level. Adjust height
by turning leveling handle in rear..
BEGIN THE LEVELING PROCESS:
When leveling high prole tooling do not continue to turn
handle past the level. Continued turning will disengage
lower linkage from all thread.
BEGIN THE LEVELING PROCESS:
Replace skirt leaving approximately 1/8” clearance above
oor.
To Next Page
Loading...
