4
EDDIE BAUER INFLATABLE SUPYAK | USER GUIDE
(ACTUAL COLOR AND MODEL MAY VARY FROM THE BOARD YOU PURCHASED)
STEP 1: Get started by registering your board with the manufacturer by visiting
registermyboard.com
IMPORTANT: Your board comes with a clear dry pouch to store valuables while on
the water. The manufacturer will not be held liable for valuables that are lost or
damaged while using this item for any reason whatsoever.
STEP 2: Open the box and unroll the board.
STEP 3: This board has two separate pieces,
the floor-board and the pontoons. Inflate the
floorboard BEFORE the pontoons.
To inflate, unscrew the valve cap from the valves
which will be on the back of the floorboard and
the sides of the SUPYAK. These valves have
two positions. The valve must be in inflation
position to inflate, meaning that air can only
move through the valve in one direction, into
the board.
When the valve stem is in inflation position,
the valve stem will stick up a little higher
than in the deflate / two-way position. Push
down on the valve stem once to switch between
positions.
STEP 4: Connect the hose to the pump,
making sure the connection is secure.
STEP 5: Plug the power adaptor into a 12-volt outlet. (Depending on your
make / model, the car may have to be running for the outlet to work)
QUICK START MANUAL
SETUP AND INFLATION
STEP 6: Press the unit toggle button
(PSI / BAR) until you reach your desired
unit.
STEP 7: Insert the hose into the valve
of the floor-board. Make sure the valve
is in inflation position before inserting
the hose.
STEP 8: Preset the pressure before inflating: Press the pressure up / down
buttons (+/ -) until you get to the target PSI / BAR. Note that while the floor-board
should be at 8 PSI / .6 BAR, each pontoon should only be
inflated to a MAXIMUM of 4 PSI / 0.28 BAR.
To Next Page
Loading...