ENGLISH
5
EDDIE BAUER INFLATABLE SUPYAK | USER GUIDE
(ACTUAL COLOR AND MODEL MAY VARY FROM THE BOARD YOU PURCHASED)
QUICK START MANUAL
SETUP AND INFLATION
STEP 9: Start the inflation process by
pressing the power button. The pump
will now start to operate. Make sure the
pump is in an open space and not in a
tight area with little air flow.
STEP 10: Once the floor-board has
reached the preset pressure, the pump
will automatically stop. Remove the hose
from the board and place the valve cap
on the board’s valve.
STEP 11: Repeat steps 7 – 10 with each pontoon. Note that while the
floor-board should be at 8 PSI / .6 BAR, each pontoon should only be
inflated to a MAXIMUM of 4 PSI / 0.28 BAR.
STEP 12: Unplug the pump from the outlet and remove the hose from the pump
and store in the bag.
STEP 13: Attach the fin. Take the base of the fin and place it at the front of the
track with the pointed part of the fin facing the back of the board. Slide the fin back
and place the fin lock in the track.
To Next Page
Loading...