ENGLISH
7
EDDIE BAUER INFLATABLE SUPYAK | USER GUIDE
(ACTUAL COLOR AND MODEL MAY VARY FROM THE BOARD YOU PURCHASED)
QUICK START MANUAL
DEFLATION & PACKING
STEP 1: Rinse off any sand or debris before storing the board, paddle,
and accessories in the included storage backpack. Remove the seat(s) from
the board.
STEP 2: Unscrew the valve caps and push the center of the valve stem
to switch the valve back to two-way air flow. Air will now come out of the board
rapidly.
STEP 3: Deflate the floor-board. Before deflating the pontoons, dump out any
water that may have accumulated. Then continue with deflating the pontoons.
STEP 4: With the valve in the deflation position, roll the board from nose to tail,
forcing the air out of the board. Be sure to roll the board with the traction pad on
the inside. Replace the valve caps once the rolling is complete and turn clockwise
to tighten.
STEP 5: Disassemble the paddle. Hold the middle shaft of the paddle with one
hand and gently pull up on one of the adjustment clips with the other about 0.64
cm (0.25 in). Remove the blade and T-grip from the shaft. Repeat with the other
blade and T-grip.
STEP 6: Store your paddle next to
your board in the bag or roll the board
around the 4 paddle pieces to protect
your paddle during transport.
IMPORTANT: For proper maintenance, empty all water from your SUPYAK before storing. If the SUPYAK is not dry, separate the pontoons and floorboard before rolling it to
prevent water accumulation. Water trapped between the pontoons and the floorboard during long-term storage can lead to corrosion, mold, and other issues that can compromise the
performance and lifespan of the SUPYAK.
To Next Page
Loading...