1. Safety Precautions
Please read this manual carefully before installations and operations
Warning signs
The warnings are used to warn the situations that may cause serious personal injury or
equipment damage with suggestions to avoid said risk.
The following warning signs are the ones used in this manual:
WARNING: This manual contains important safety and operating instructions. Read
this manual carefully before installations and operations, keep it for future reference.
1. Before using the unit, read all instructions and cautionary markings on the unit, the batteries
and all appropriate sections of this manual.
2. Do not disassemble the unit. Take it to a qualified service center when service or repair is
required. Incorrect re-assembly may result in a risk of electric shock or fire.
3. To reduce risk of electric shock, disconnect all wrings before attempting any maintenance or
cleaning. Turning off the unit will not reduce this risk.
4. NOTICE – Only qualified personnel can install this device with battery.
5. Be very cautious when working with metal tools on or around batteries. A potential risk exists
to drop a tool to spark or short circuit batteries or other electrical parts and could cause an
explosion.
6. Please strictly follow installation procedure when you want to disconnect DC terminals. Please
refer to INSTALLATION section of this manual for the details.
7. GROUNDING INSTRUCTIONS -Inverter should be connected to a permanent grounded wiring
system. Be sure to comply with local requirements and regulation to install.
8. NEVER cause AC output and DC input short circuited.
9. Warning!! Only qualified service persons are able to service this device. If errors persist
after following troubleshooting table, please contact customer service or after-sales team in
time.
Danger
Failure to comply with the relevant requirements will
result in serious electrical shock and personal injury.
Warning
Failure to comply with relevant requirements may lead to
personal injury or equipment damage.
High
temperature
The base of the inverter generates high temperature. Do
not touch that area.
NOTICE NOTICE Steps need to be taken to ensure correct operation.
To Next Page
Loading...
