LCDI plug wring instruction :
This unit is provided with Leakage Current detection interruption circuit (LCDI )built
into the plug of the power supply cord . This device provides protection to reduce the
risk of fire due to arcing faults in the power–supply cord. Before use, follow the “Plug
Testing Instructions” to ensure that the LCDI circuit is functioning properly:
Plug Testing Instructions:
1. Press Test Button.
Unit should trip.
2. Press Reset Button
firmly
DO NOT USE IF THE ABOVE TEST FAILS
Do not use the TEST and RESET buttons as an on/off switch. They are only meant to be
used to periodically check the LCDI plug
CALL CUSTOMER SERVICE IF TEST FALLS
22
To Next Page
Loading...
Need help?
General
