7
Installation
The refrigerator should be installed in accordance with local electrical code requirements. The refrigerator
should also be placed in a location that is strong enough to support its total weight, keeping in mind that
it will weigh substantially more when fully loaded than when empty. Before you plug the refrigerator
into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s
oils to settle.
Unpacking the Refrigerator
Warning: Use two or more people to move and install the refrigerator. Failure to do so
can result in back or other injury. Carefully remove the packaging materials. Remove any
shipping tape and glue from your refrigerator before use. Do not use sharp instruments,
rubbing alcohol, ammable uids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator.
!
Warning: Do not remove any safety, warning, or product information labels from your
refrigerator.
!
This refrigerator has been designed for freestanding installation. This will allow you to install the
refrigerator in almost any place you desire. You must follow the stated instructions for electrical
requirements and leveling the refrigerator.
Notes:
• This unit MUST be installed in an area protected from the elements, e.g. wind, rain,
water spray, or drips.
• The refrigerator should not be located next to ovens, grills, or other heat sources.
• Do not kink or pinch the power supply cord between the refrigerator and the wall or
cabinet.
!
Clearance Requirements
Leave 8” of space on either side of the refrigerator, 6” at the rear, and 8” above the unit.This will allow
cold air to circulate around the refrigerator and improve the eciency of the cooling process. The door
can be opened to the right or the left, depending on what best suits the location. Please ensure there is
adequate space for the door to fully open.
6”
8”
6”
8” 8”
Top View:Side View:
To Next Page
Loading...
Need help?
General
