EdgeStar CWB2886FD - Installing and Removing Shelves

7
Installing the Door Handle
To install a door handle:
1. Open the door and carefully pull back the door gasket around the area where the handle
is to be installed.
2. Insert each Phillips head screw through the gasket side of the door until the screw passes
through the door.
3. Align the handle with the screws and tighten using a Phillips head screwdriver until the
handle is flush against the door frame.
4. Carefully press the door gasket into its original position.
5. Repeat these steps for the next door.
Installing and Removing the Shelves
To prevent damaging a door gasket, make sure to open each door all the way before pulling
the shelves out of their track.
To Install the Shelves:
1. Open the door completely.
2. Identify the protective stoppers located on the right and left sides of the back of each
shelf.
3. Lift either the left or right side of the shelf creating a 45° angle. Insert the shelf at the
desired track level and push it back slowly until it stops in place.
4. Gently lower the shelf down onto the track. It should be level.
To Remove the Shelves
1. Open the door completely.
2. Make sure the shelf is pushed back completely (towards the rear wall).
3. If necessary, make sure you remove all the contents sitting on the shelf.
4. Identify the protective stoppers located on the right and left sides of the back of each
shelf.
5. Lift either the left or right side of the shelf, creating a 45° angle from its original
position. Make sure not to lift either side of the shelf too hard as it may come in
contact with the inner wall mount.
6. Pull the shelf forward until it is completely removed from the inner compartment. Set
the shelf aside safely.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless steel door.