8
Operation
Installation Check List Before Operation
1. Have all packing materials and tape been removed from the interior and exterior of the
wine and beverage refrigerator?
2. Have the installation instructions been followed, including connecting the machine to
electricity? And has proper grounding been installed for the wine and beverage
refrigerator?
3. Has the machine been leveled?
4. Is the wine and beverage refrigerator in a site where the ambient temperature is
between 50° F and 90° F all year round?
5. Is there a clearance of at least 1-2” at the rear, 1/4” at the top, and 1/4” at the sides for
proper air circulation?
Using the Temperature Control Panel
This wine and beverage refrigerator has two cooling zones that are controlled independently
by two separate control panels, one for the left side zone and one for the right side zone. The
left wine zone has a temperature range from 40° F to 65° F. The right beverage zone has a
temperature range from 38° F to 65° F. The control panel in each zone will display the set
temperature inside the cabinet.
• Up Button : Press the button on the control panel to increase the temperature by 1
degree increments.
• Down Button : Press the button on the control panel to lower the temperature by 1
degree increments.
• RUN LIGHT: When lit, the unit is in cooling mode
• Light Button : Press the button to turn the inner light on or off.
• Power Button : Turns the unit on and off (press and hold this button for approximately 3
seconds).
To Next Page
Loading...
