EdgeStar CWB2886FD - Installation Guide; Unpacking the Refrigerator

4
Warning: Use two or more people to move and install the wine and beverage refrigerator.
Failure to do so can result in back or other injury. Carefully remove the packaging materials.
Remove any shipping tape and glue from your wine and beverage refrigerator before use. Do
not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the surface of your wine and beverage refrigerator.
Important: Do not remove any safety, warning, or product information labels from your wine
and beverage refrigerator.
Installing the Wine and Beverage Refrigerator
The wine and beverage refrigerator should be installed in accordance with local electrical code
requirements. The wine and beverage refrigerator should also be placed in a location that is
strong enough to support its total weight, keeping in mind that it will weigh substantially more
when fully loaded than when empty. Before you plug the wine and beverage refrigerator into
a power supply, be sure to let it stand upright for at least 24 hours to allow the
compressor’s oils to settle.
Unpacking the Wine and Beverage Refrigerator
Types of Installation
This wine and beverage refrigerator has been designed for freestanding or built-in installation.
In each case, there must be adequate ventilation and access for service.
Freestanding Installation:
A freestanding installation will allow you to install the wine and beverage refrigerator in
almost any place you desire. You must follow the stated instructions for electrical
requirements, and leveling the wine and beverage refrigerator.
Built-in Installation:
A recessed installation will allow you to install the wine and beverage refrigerator under a
counter or in a kitchen cabinet as long as the required clearance space around the wine
and beverage refrigerator is provided. It is necessary to allow adequate ventilation space
around the unit, including at the back of the unit. The following additional items must be
observed:
1. Place the wine and beverage refrigerator in front of the installation location. Adjust the
feet and place the unit flat on the floor or on a platform depending on your installation
requirements.
2. If the electrical outlet for the wine and beverage refrigerator is behind the cabinet,
plug in the wine and beverage refrigerator.
3. Push the wine and beverage refrigerator into position.
Warning: DO NOT install the wine and beverage refrigerator behind a closed cabinet door.
Tip: Gather the model and serial number from the product label and write them down before
installing the wine and beverage refrigerator.