EdgeStar CWF440SZ - Leveling the Wine Refrigerator; Installing the Door Handle

5
Important: Once you are ready to install the unit in a cabinet or directly on the floor, you must
adjust the feet to level the wine refrigerator.
Note: Some wine refrigerators do not have decorative plugs installed.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless steel door.
Recommended Grounding Method
For your personal safety, this appliance must be grounded. It is equipped with a power
supply cord that has a 3-pronged grounding plug. To minimize possible shock hazard, the
cord must be plugged into a mating 3-pronged wall socket, and grounded in accordance
with the National Electrical Code and local codes and ordinances. If a mating wall socket is
not available, it is the personal responsibility of the customer to have a properly grounded,
3-prong wall receptacle installed by a qualified electrician.
Leveling the Wine Refrigerator
It is important for the wine refrigerator to be level in order to work properly. It can be raised or
lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If
you find that the surface is not level, rotate the feet until the wine refrigerator becomes level .You
may need to make several adjustments to level it. We recommend using a carpenter’s level to
check the machine.
1. Place a carpenter’s level on top of the product to see if the wine refrigerator is level from front
to back and side to side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the refrigerator.
Turn the leveling feet to the left to raise that side of the refrigerator.
Installing the Door Handle
To install a door handle:
1. Open the door and carefully pull the door gasket around the area where the handle will be
installed.
2. Carefully remove the two pre-installed decorative plugs from the front of the door.
3. Insert each Philips head screw through the gasket side of the door until the screw passes
through the door.
4. Align the handle with the screws and tighten them using a Philips head screwdriver until
the handle is flush against the door frame.
5. Carefully press the door gasket into its original position.