13
expansion and contraction of the fuel in the tanks. DO NOT SMOKE OR INTRODUCE AN OPEN
FLAME NEAR THE FUEL CAPS!
4.4 Fueling
Your EdgeWater 245CX is equipped with a built-in 120 gallon fuel tank. Before fueling, you
should follow these procedures.
•
Make
sure the boat is securely moored and engines are turned off.
•
Make
sure all switches are off and all cigarettes and open flames are extinguished.
•
Know
the location of all fire extinguishers.
•
Remove
the fuel fill cap.
•
Place
the nozzle firm against the side of the opening to prevent static discharge
•
Begin
fueling.
•
DO
NOT OVERFILL.
•
Re-install
the fuel cap.
•
Check
the bilge area for fuel odors.
Warning: If fuel odors are detected, do not start the engine! Check to make certain there
are no leaks or system problems before starting the engine.
Warning: Do not fill the fuel tank while the engine is running. Do not allow smoking or
open flames within 50 ft. of the fueling area. Fuel is very flammable. To prevent damage to
the engine, use only fuels without harsh additives or alcohol. Refer to your engine owner’s
manual for specific fuel requirements.
4.5 Fuel System Maintenance
Regularly inspect the fuel system components. All lines, fittings, and bulbs should be flexible and
not corroded. If fittings or other components are found to be cracked, they should be replaced at
once. If you use your boat infrequently or do not use it for an extended period of time, a fuel
conditioner should be added to a full tank of fuel to prevent fuel deterioration and damage to the
fuel system.
4.6 Fuel Filters
A fuel filter is installed in the transom area of your EdgeWater 245CX. This is a 10-micron
fuel/water separator type of filter and is designed to prevent water from entering your engine. The
fuel filter element is a spin-off type element. At a minimum, this element should be replaced at the
beginning of every boating season. Always carry a filter wrench and spare filter of the type
supplied on your boat.
To Next Page
Loading...
