EasyManua.ls Logo

Edgewater Networks 245CX - Page 17

Default Icon
224 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
Operating instructions for the freshwater system
1. Fill holding tank with drinkable water, using water fill located on the starboard side
gunwale.
2. Turn on freshwater pump switch, located on the dash switch panel.
3. Utilize all freshwater equipment. (Transom shower STD)
4. If the system has not been used for a while please allow a few minutes for the pump
to prime up.
Troubleshooting tips
1. You can hear the pump running, but no water is coming out of the spray head.
a. The holding tank is empty, fill with water.
b. The pump has not yet primed, hold hand over nozzle while squeezing the
trigger. This will help to prime the pump.
2. The pump will not run at all.
a. Check the breaker on the dash switch panel.
b. Make sure the battery switches are in the “ON” position.
c. Check the connections at the switch and at the pump itself.
6.5 Raw Water System Maintenance
The following checks should be made periodically to assure your system operates properly:
·
Periodically spray pumps with a protective silicone solvent to reduce corrosion.
·
Periodically check the strainer, located under the starboard side transom locker, to remove any
collected debris.
·
Fishboxes and livewells should be drained and cleaned after each use.
·
Periodically check hoses and connections for signs of deterioration.
7/Drainage System
7.1 General
All non-bilge water drains from your EdgeWater 245CX by gravity. Your boat is self-bailing at rest.
It is important to check drains frequently to make sure they are clear and free flowing. Review the
schematic in the Appendix and become familiar with the location of each thru-hull drain.
7.2 Drain System Maintenance
Essential tasks must be done periodically to maintain your boat’s ability to drain in adverse
conditions.
Clean cockpit drains to remove debris or other foreign objects which could prevent boat from
draining properly.
Check bilge area for debris and foreign material, which can cause automatic switches to
malfunction.
Flush drains to keep free flowing and clean.

Related product manuals