• If use one earbud only, please take the left or right earbud out of the charging case, and refer
to the procedures mentioned in "Two earbuds mode" to pair with Bluetooth devices.
• Take the earbuds out of the charging case, they will auto-connect to the Bluetooth device
connected successfully last time.
• When the earbuds are disconnected from Bluetooth device for not at the effective distance,
they can auto-connect to the Bluetooth device again if return to the effective distance within 3
minutes.
The left and right earbuds have finished TWS pairing before leaving factory. If the wireless
connection fails to resume, please follow the steps below to re-pair:
• After the earbuds are powered on, simultaneously double click the touch zones of the left and
right earbuds to start TWS pairing(prompt tone: beep);
• After TWS pairing is done, the earbuds will enter Bluetooth pairing state, and there will be
prompt tone;
• Please refer to the procedures mentioned in "Two earbuds mode" to pair with Bluetooth devices
again.
One earbud mode
Reconnect automatically
TWS pairing of the left and right earbuds
■ Bluetooth connection
To Next Page
Loading...
