Maintenance and repair
During usage, please read the following suggestions which would help you
follow the warranty terms and make the product life longer.
● Keep the product dry and far from any damp places in order to avoid the
affect on the product’s internal circuit. You should avoid using the product
during intense exercise or when you sweat too much.
● Do not place the product directly under the sun or where the temperature
is high. High temperature will shorten the electronic components’ life and
damagebatteries.
● Do not put the product at very cold places in order to prevent its internal
circuit board from being damaged.
● Do not dismantle the product. Non-technician may damage the product.
● Do not drop, violently vibrate or strike the product with hard items in order
to prevent its internal circuit from being damaged.
● Do not use strong chemical products or detergent to clean the headphone.
● Do not use any sharp items to scratch the product surface in order to
prevent its casing from being damaged. and its outlook from being affected.
If the product cannot work properly, please send it to your qualified service
organizations. The staff shall help you with their whole heart.
Note:
After the factory settings are restored, the paired list of the headphone will
be deleted. The headphone will automatically enter the pairing mode after
turning on.
The headphone will not automatically connect any device. If the headphone
needs to connect any device, the new pairing is required.
Restore factory settings
Turn off the headphone, press and hold volume increase button about
3 seconds while charging and release the button when the red and blue
light blinks at the same time. Meanwhile you will hear an indicator tone.
8
To Next Page
Loading...
