EasyManua.ls Logo

EdilKamin IDROFLEXA - Page 22

EdilKamin IDROFLEXA
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 22 -
ENGLISH

The answers are listed below in summary form, for further details see the other pages of this document.

Smoke outlet that is at least 80 mm in diameter.
An air inlet in the room that is at least 80 cm².
¾” G outlet and inlet tting.
¾” G drains connection for overpressure valve.
¾” G load tting.
A certied electrical connection with a thermal magnetothermic switch 230V +/- 10% 50 Hz.
(assess the division of primary and secondary circuits).

NO. Using the boiler-stove without water will damage it.

NO. Most of the heat is transferred to the water.
Emit a small amount in the installation environment in the form of radiation from the glass hearth. It is advisable in any case to
use a radiator in the same room.

NO, just like other boilers, it must be connected to a collector from which the water is then distributed to the radiators.

It is possible to produce hot sanitary water evaluating the power of the stove and the water plant.

NO, a discharge which is conform with standards (UNI 10683/05) must reach the ridge of the roof, and in any case proper fun-
ctioning requires a vertical stroke of at least 1.5 meters; avoiding that in case of power outage or wind, a slight amount of smoke
forms in the installation environment.

Yes, to replenish the air used by the boiler-stove for combustion. The smoke extractor draws the air from the room into the com-
bustion chamber.

The desired water temperature or that of the room; the boiler-stove will then adjust the power accordingly to obtain or maintain
this.
For small systems, a mode can be set that ignites and shuts down the boiler-stove accordingly, as the water temperature is reached.
(contact DEALER for initial start up)

Before you ignite the boiler-stove, every time, when it is off and cold. AFTER HAVING BRUSHED THE EXCHANGER PIPES
and moved the smoke duct cleaning rods (see page 18).

Yes, at least once a month when the boiler-stove is not used for some time.

NO. The boiler-stove has been designed to burn wood pellets that are 6 mm in diameter. Any other material can damage it.

Other manuals for EdilKamin IDROFLEXA

Related product manuals