Edimax EW-7416APn Quick Installation Guide

5
This is where you connect the antenna. It is a round connector
(standard Reverse SMA).
z 12 VDC
This is where you connect the power adapter.
z WPS/Reset
Reset the router to factory default settings (clear all settings) or
start WPS function. Press this button and hold for 20 seconds
to clear all settings, and press this button for less than 5
seconds to start WPS function.
z 10/100M (EW-7416APn )
This LAN port is where you connect the Access Point to your
Ethernet devices (switch or router).
W
W
i
i
r
r
e
e
l
l
e
e
s
s
s
s
L
L
A
A
N
N
A
A
c
c
c
c
e
e
s
s
s
s
P
P
o
o
i
i
n
n
t
t
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
To configure the other advanced settings of this Access Point with
advanced setting such as data encryption, please follow the
procedures to login the Access Point’s setup page.
To configure the more advanced settings from this Access Point,
such as data-encryption, please follow the procedure to login the
Access Point’s setup page.
The IP address of the Access Point is 192.168.2.1
First, assign an IP Address to the PC
Before assigning an IP address to the PC, please connect a
network cable from the LAN port of the PC to the LAN port of the
Access Point as show below.

Edimax EW-7416APn Specifications

General

Interface	10-100M UTP Port x 1
Networking features	IEEE 802.11b/g/n
Antenna type	External
Antenna features	Dipole antenna, Detachable antenna
Antennas quantity	2
Antenna gain level (max)	3 dBi
Flash memory	4 MB
Internal memory	16 MB
Built-in processor	Yes
Output voltage	12 V
Output power description	11n: 15±1dBm, 11g: 15±1dBm, 11b: 18±1dBm
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Certification	FCC, CE
Security algorithms	802.1x RADIUS

Weight and Dimensions

Dimensions (WxDxH)	127 x 96 x 30 mm