3. Install the Flush kit / Solenoid valve on the pump.
▪ Remove the screw from the canopy.
▪ Place the Flush kit / Solenoid valve on the pump and make sure it is levelled,
b
y sliding it up and down the slot of the bracket.
▪ Tighten the hex head cap screw to x the posion.
1. Screw
4. Fit the Non-Return Valve (NRV) to the pump.
▪ Loosen the nut of the NRV so that the NRV ng c
an rotate freely on the pipe.
Make sure that the nut is not completely removed.
▪ Fit the NRV into the adapter.
▪ Tighten the nut.
1. Nut
2. NRV
05/2021 - ©Edwards Limited
Page 14A41892880_C
A41892880_C - Ins
tallaon
To Next Page
Loading...
