Edwards EDS200

4.2 Ins
tallaon on the pump with canopy (for EDS200 and EDS300
pumps)
Follow these steps to install the Flush kit /Solenoid valve on your pump:
1. Prepare the Flush kit / Solenoid valve for installaon.
A. Flush kit / Solenoid valve
B. Aach the br
acket to the Flush kit / Solenoid valve with the hex head cap
screw
C. Flush kit / Solenoid valve with bracket
Note:
Do not fully gh
ten the hex head cap screw, so that the bracket posion can
be adjusted.
2. Replace the plug screw with the adapter.
▪ Replace the plug screw adjacent to the pump inlet with the supplied adapter.
1. Plug screw
2. Adapter
05/2021 - ©Edwards Limited
Page 13A41892880_C
A41892880_C - Ins
tallaon