BRUSCHCUTTERS DS 2200 - DS 2400
pag. 9
Workshop manual
2. SAFETY
Work In Ventilated Area
Engine exhaust fumes can cause sickness or
death. If it is necessary to run an engine in an
enclosed area, remove the exhaust fumes from
the area by opening doors to get outside air into
the area.
Warning: California Proposition 65 Warning
Gasoline engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects, or other
reproductive harm. Remove Paint Before Welding
or Heating Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint
is heated by welding, soldering, or using a torch.
Do all work outside or in a well ventilated area.
Dispose of paint and solvent properly. Remove
paint before welding or heating: If you sand or
grind paint, avoid breathing the dust. Wear an
approved respirator. If you use solvent or paint
stripper, remove stripper with soap and water
before welding. Remove solvent or paint stripper
containers and other ammable material from
area. Allow fumes to disperse at least 15 minutes
before welding or heating.
Avoid Injury From Rotating Blades
Keep hands and feet away while machine is
running. Shut off power to service, lubricate, or
remove blades.
Handle Chemical Products Safely
Direct exposure to hazardous chemicals can cause
serious injury. Potentially hazardous chemicals
used with EMAK equipment include such items as
lubricants, coolants, paints, and adhesives.
Dispose of Waste Properly
Improperly disposing of waste can threaten the
environment and ecology. Potentially harmful
waste used with EMAK equipment include such
items as oil, fuel, coolant, brake uid, lters, and
batteries. Use leakproof containers when draining
uids. Do not use food or beverage containers
that may mislead someone into drinking from
them. Do not pour waste onto the ground, down
a drain, or into any water source. Inquire on the
proper way to recycle or dispose of waste from
your local environmental or recycling center, or
from your EMAK dealer.
Live With Safety
Before returning machine to customer, make sure
machine is functioning properly, especially the
safety systems. Install all guards and shields.
To Next Page
Loading...
Need help?
General
