What to do if Efco Trimmer engine will not start or runs only briefly?
If your Efco Trimmer engine won't start or only runs for a few seconds, here's what you can do: 1. Check for a spark at the spark plug tip. If there's no spark, try again with a new spark plug (CMR7H). 2. If the engine is flooded, follow the procedure on page 28. If it still doesn't start, repeat the procedure with a new spark plug.
Why Efco Trimmer engine does not reach full speed and emits excessive smoke?
There are several reasons why your Efco Trimmer engine may not reach full speed or might emit excessive smoke: 1. Check the fuel mixture. Use fresh fuel and the correct 2-cycle oil mix. 2. The air filter might be dirty. Clean it following the instructions in the Maintenance-Air Filter Section. 3. The carburetor may require adjustment. Contact a Servicing Dealer for carburetor adjustment.
General| Brand | Efco |
|---|---|
| Model | DS 2400 T |
| Category | Brush Cutter |
| Language | English |
To Next Page
