en
12
SAFETY RULES
at idle speed, the carburetor may need
adjusting, see Operation-Carburetor
Adjusting Section. If the cutting attachment
still moves at idle speed after adjustment
has been made, contact a Servicing
Dealer for adjustment and discontinue use
until the repair is made.
WARNING: All brush cutter
service, other than items in the
Operator’s Manual maintenance
instructions, must be performed
by competent brush cutter service
personnel. (If improper tools are
used to remove the fl ywheel or
clutch, or if an improper tool is
used to hold the fl ywheel in order
to remove the clutch, structural
damage to the fl ywheel could
occur which could cause the
fl ywheel to burst and serious
injury could result.)
• Never modify your brush cutter in any way.
• Keep the handles dry, clean, and free of oil
or fuel mixture.
WARNING: Use only recommended
accessories and replacement parts.
• Never touch the cutting attachment or
attempt to service the brush cutter while
the engine is running.
• Never use fuel for cleaning operations.
• Keep the brush cutter in a dry place, off
the ground with the blade guard on and the
tanks empty.
• If your brush cutter is no longer usable,
dispose of it properly without damaging the
environment by
handing it in to your local Dealer who will
arrange for its correct disposal.
• Replace immediately any safety device
when damaged or broken.
WARNING: The muffl er and other
parts of the engine (e.g. fi ns of
the cylinder, spark plug) become
hot during operation and remain
hot for a while after stopping the
engine.
To reduce risk of burns do not
touch the muffl er and other parts
while they are hot.
To Next Page
Loading...
Need help?
General
