How to fix Efco MT 8200 that won't start?
If your Efco Chainsaw engine doesn't start or shuts off shortly after starting, and you've confirmed the switch is in the “I” position: 1. Check for a spark at the spark plug. If there's no spark, try again with a new spark plug (BPMR8Y). 2. Your engine might be flooded. Follow the procedure on page 20. If it still doesn't start, try the procedure again with a new spark plug.
Why is my Efco MT 8200 chain smoking?
If the bar and chain on your Efco Chainsaw are heating up and smoking, here's what to check: 1. Ensure the chain oil reservoir is full. Refill it every time you refill the fuel tank. 2. Check the chain tension. Adjust it according to the instructions to avoid overtightening. 3. Run the chainsaw at full throttle for 15-30 seconds, then stop it and see if oil drips from the bar's tip. If oil is present, the issue might be a loose chain or a damaged bar. If there's no oil, contact an Authorized Service Center.
How to adjust idle on Efco MT 8200?
To adjust the idle speed on your Efco Chainsaw, adjust the minimum speed screw “T” (Fig.84, pag.39) clockwise to increase the speed; see chapter Carburetor maintenance.
What to do if Efco MT 8200 chain won't turn?
If your Efco Chainsaw starts but the chain isn't rotating, here’s what to check: 1. Make sure the chain brake is disengaged. 2. Check the chain tension and adjust if it's too tight. 3. Inspect the assembly of the bar and chain. 4. Inspect the chain and/or the bar for damage. 5. If necessary, replace the clutch and/or sprocket or contact an Authorized Service Center.
To Next Page
General
