Efco PA 1030 User Manual (English)

Questions and Answers:

K
kristen49Aug 2, 2025
Why Efco Water Pump engine does not reach full speed and emits excessive smoke?
- A
  Allison MasseyAug 3, 2025
  If your Efco Water Pump's engine doesn't reach full speed or emits excessive smoke, check the following: 1. Ensure you are using fresh gasoline and the correct two-stroke engine oil mixture. 2. Clean the air filter according to the maintenance instructions. If the issue persists, the carburetor may need adjustment, and you should contact an Authorized Service Center.
M
Mark ClarkAug 9, 2025
What to do if Efco PA 1030 Water Pump engine starts, but does not accelerate correctly?
- R
  Rodney AdamsAug 9, 2025
  If your Efco Water Pump engine starts but doesn't accelerate correctly or doesn't function properly at high speed, it might be due to the carburetor needing adjustment. Contact an Authorized Service Center to have the carburetor adjusted.
M
Margaret FordAug 15, 2025
What to do if Efco PA 1030 engine starts, but the water flow rate is poor?
- L
  Lori RogersAug 15, 2025
  If your Efco Water Pump engine starts and rotates, but the water flow rate is poor, here's what you can check: 1. The suction filter might be clogged, so clean it. If the issue persists, the impeller may be damaged or worn, and you should contact a servicing dealer.
M
mirandabakerAug 20, 2025
How to fix Efco PA 1030 when engine does not start?
- C
  Christine LawsonAug 20, 2025
  If your Efco Water Pump engine won't start or shuts off after a few seconds (ensure the switch is in the "I" position), here are a couple of things to check: 1. Check for a spark at the spark plug. If there's no spark, try again with a new spark plug (RCJ-7Y). 2. The engine might be flooded. Follow the procedure on page 18. If it still doesn't start, try again with a new spark plug.