18
MAINTENANCE
Maintenance Chart
Please note that the following maintenance intervals apply for normal operating conditions
only. If your daily work requires longer than normal or harsh cutting conditions are present
the suggested intervals should be shortened accordingly.
Complete Machine
Controls (Ignition Switch, Choke Lever, Throttle
Trigger, Trigger Interlock)
Fuel Tank
Grease Nipple
Fuel Filter
Blade
Clutch Drum
All Accessible Screws and Nuts (Not Adjusting
Screws
Air Filter
Cylinder Fins
Starter System Vents
Starter Rope
Carburetor
Spark Plug
Vibration Mounts
Inspect (Leaks, Cracks, and Wear)
Clean
Check Operation
Inspect (Leaks, Cracks, and Wear)
Clean
Inspect (Leaks, Cracks, and Wear)
Clean
Inspect
Clean, Replace Filter Element
Inspect (Damage, Sharpness, and Wear)
Sharpen (Check Gauge Depth)
Inspect (Damage, and Wear)
Replace
Inspect
Retighten
Clean
Replace
Clean
Clean
Inspect (Damage and Wear)
Replace
Check ldle (Chain must not rotate at ldle)
Check Electrode Gap
Replace
Inspect (Damage, and Wear)
Replace by Dealer
Before Each Use
After Each
Refueling Stop
After Finishing
Daily Work
Weekly
Monthly
If Damaged or
Faulty
As Required
Every 6
Months
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Every 6
Months
X
Every 6
Months
en
Efco TG2600 Inglese 29-03-2007 14:21 Pagina 18
To Next Page
Loading...
Need help?
General
