SpeedStream 5200 Series Bridge
Verification and Troubleshooting 7
77
7
Verification and Troubleshooting
Verification and TroubleshootingVerification and Troubleshooting
Verification and Troubleshooting
Verify Your DSL Connection
Verify Your DSL ConnectionVerify Your DSL Connection
Verify Your DSL Connection
To verify that your DSL connection has been established, use any network
application (such as your web browser) to access material on a remote network or
the Internet.
Nothing happens when I enter an address into my browser. How can I find
Nothing happens when I enter an address into my browser. How can I find Nothing happens when I enter an address into my browser. How can I find
Nothing happens when I enter an address into my browser. How can I find
and correct what is wrong?
and correct what is wrong?and correct what is wrong?
and correct what is wrong?
1 Verify that the bridge’s power is switched ON.
2 Check the LINK light on the PC network interface card. If it is not green,
check the cable to the bridge is securely connected.
3 Confirm that the first three lights on the front of the bridge glow green. If
they do not, consult the Lights table in this guide to check the sequence of
light changes during bridge initialization (the first thirty seconds after
switching on power).
4 Check that your workstation is properly configured. Verify that TCP/IP
protocol software is loaded and configured with all necessary settings
specified by your Network Service Provider (NSP). Review the
Configuration section of this guide for a TCP/IP example configuration in
Microsoft Windows™.
5 Ping the Gateway address provided by your NSP. To do so using Microsoft
Windows, under Start >Run, type
ping <gateway address>. If you
do not receive a reply, there is a circuit problem between your DSL jack and
your NSP gateway. Contact your NSP for resolution.
6 Using the same method as above, ping the DNS address provided by your
NSP (e.g.
ping <DNS address>). If you do not get a reply, DNS is
down. Contact your NSP for resolution.
7 Review your browser and network settings to ensure the connections are
being attempted through your SpeedStream 5200 Series Bridge and not
some other device (such as a dialup modem).
To Next Page
Loading...
Need help?
General