C556 Self Powered Elliptical Fitness Crosstrainer
Page 52
7. Feed the upper interconnect cable into the replacement upper main column and fasten the
display housing to the replacement upper main column with the screws removed in step 7.
8. Draw the upper interconnect cable out of the access hole at the bottom of the upper main
column as shown in Diagram 7.14.
9. Set the upper main column at it’s mounting position, hand start the four mounting bolts
removed in step 5. Torque the mounting bolts to 100 inch pounds.
10. Connect the upper interconnect cable to the mid-point connector. Carefully push the
interconnect cables into the upper main column access hole.
11. Replace the mid-point cover per Procedure 7.1.
To Next Page
Loading...