56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC30
◾
Do not fell trees near electrical wires or buildings.
◾
Cut only when visibility and light are adequate for you to see clearly.
Proper Grip On Handles
◾
Wear non-slip gloves for maximum
grip and protection.
◾
With the saw on a firm, flat surface,
hold the saw firmly with both hands.
◾
Always grasp the front handle with
the left hand and the rear handle
with the right hand.
◾
The fingers should encircle the
handle, with the thumb wrapped under the front handle (Fig. 13).
WARNING:
Never use a left-handed (cross-handed) grip, or any stance which
would place your body or arm across the chain line.
WARNING:
Do not operate the
variable-speed trigger switch with your
left hand and hold the front handle with
your right hand. Never allow any part of
your body to be in the chain line while
operating a chain saw (Fig. 14).
Proper Cutting Stance (Fig. 15)
◾
Both feet should be on solid ground,
with weight evenly spread between
them.
◾
The left arm should be straight,
with the elbow locked. This helps to
withstand the forces generated by
kickback.
◾
Your body should always be to the
left of the chain line.
13
Grip with thumb
below handle
14
Chain line
15
Chain line
Straight Arm
Position
To Next Page
Loading...