ZERO TURN RIDE-ON MOWER — ZT4200E-S 65
EN
PROBLEM CAUSE SOLUTION
The zero turn ride-on
mower fails to start
the blades when the
PTO switch is
activated.
PTO Switch icon blinks
◾ The combined Ah of the
inserted batteries does
not meet the
requirement.
◾ In order to start this mower, use enough EGO
batteries following the instructions in section
“ATTACHING/DETACHING THE BATTERY
PACK” in
this manual.
◾ The PTO switch was not
pushed down when the
mower was turned off
last time.
◾ Push the PTO switch down and then up to restart
the blade motors.
◾ The mower is overloaded
at the moment the blades
are starting to rotate,
triggering the motor self-
protection.
◾ Start the mower grass cutting in lower blade
speed first and do not accelerate the blade
speed until the blades are rotating successfully.
◾ Under extreme cold
weather, the blade motor
may not start successfully
due to the low temperature
protection.
◾ Always store the mower and battery in warm
environment. Restart the mower when it is
warmed up. Please do not make repeated
attempts under extreme cold weather which may
damage the machine.
◾ The blade interferes with
the deformed mower deck
◾ Call EGO Customer Service Center.
◾ The mower is driving
at “TRAVEL” speed.
◾ When the mower is driving at “TRAVEL” speed,
the blade motors will automatically stop.
To Next Page
Loading...
