To Next Page

To Previous Page

EARTH/ICE AUGER — EG0800/EG0800-FC/IG0800/IG0800-FC 21

To Install the Ice Auger Bit

(Fig. 4a & 4b)

Required tool (provided):

Allen key (6 mm)

1. Loosen and remove the locking

screw from the ice auger bit.

2. Mount the upper end of the auger

bit onto the drive shaft of the power

head.

3. Align the connection holes on the

auger bit and drive shaft.

4. Use the locking screw to secure

the auger bit to the drive shaft. Use

the 6 mm Allen key to tighten the

locking screw securely.

NOTICE: Make sure the locking screw is

inserted in the connection holes from the

ﬂat side of the auger bit hole.

Drive Shaft

Ice Auger Bit

Drive Shaft

Locking Screw

Flat Side

Questions and Answers:

Need help?

Do you have a question about the EGO EG0800 and is the answer not in the manual?

EGO EG0800 Specifications

General