Ego® Page 5
Ref: EGO300-UM-1013-Rev.A
Before use, always check the mover for any damage.
When towing or moving the caravan please be aware, at all times, that ground clearance is reduced by 50mm
when the Mover has been tted.
To maintain signal strength, always make sure that, during manoeuvring, the distance between the remote
control and the caravan does not exceed 5 metres.
DO be aware that the mover increases your caravan or trailer weight. So this reduces the payload of the
caravan.
DO always make sure that the rollers are fully disengaged from the tyres when the mover is not in use. This is
better for the tyres and for the mover.
DO always make sure that the rollers are fully disengaged before towing/moving the caravan by vehicle or
manpower. This can damage the tyres, mover and the towing vehicle.
DO always make sure that the remote control is stored in a safe place (out of reach of children or other
unauthorised people).
DO always apply the handbrake after manoeuvring, before disengaging the drive rollers from the tyres.
DO always ensure that children and pets are kept well out of the way during operation.
DO NOT rely on the mover to act as a brake.
DO NOT exceed the total Safe Working Load (SWL).
DO NOT make any modications on the caravan mover (mechanical or electronically). This can be very
dangerous! No warranty claim will be accepted and we cannot guarantee the function of the mover if any
modications are made. We will not be liable for any damage whatsoever caused as a result of incorrect
installation, operation or modication.
Operation - Safety Guidelines
Operation - Set-Up
Before you use your mover system you need to locate the Carry Case (6) that contains the Control Unit (7) and cables in
the caravan doorway or in an externally accessible locker.
First, unwind the motor cable and connect both motor plug connectors onto both motors (the plug connectors are col-
our coded). Please refer to Fig.16.
Safety First! Only unwind the minimum amount of cable that is required between the motors and the Carry Case
as it is important that the cable cannot get caught on any moving parts or does not drag on the ground. The
cable between the motors and the control unit should be taut but not overtight in order to avoid straining any
plug connectors.
You can then unwind the battery cable from the Carry Case and connect to your 12V battery power source.
Caution! Make sure that you do not reverse the Positive (+) and Negative (-) connections. Incorrect connection
(reverse polarity) may result in damage to the Control Unit.
To Next Page
Loading...
General