To Next Page

To Previous Page

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC 29

VARIABLE-SPEED SELF-PROPEL SYSTEM (only for LM2100SP/

LM2100SP-FC)

LM2100SP/LM2100SP-FC mower is equipped with variable-speed self-propel capability.

This system is independent of the blade On-Off switch; it is not dependent on blade

rotation. For example, when you have completed cutting your lawn, you can use the self

propel to propel the mower back to your storage location without blade rotation. Or you

may choose to operate the mower as a non-self-propelled mower to maximize battery

run time.

To operate the self-propel system without

blade rotation, pull the self-propel trigger

to the handle.

To turn the self propel off, release the

self-propel trigger (Fig. 17).

The system has variable speed. To

increase the speed, move the self-propel-

speed-control lever forwards. To decrease

the speed, move the self propel speed

control lever backwards.

To operate with the blade rotating for cutting:

1. Depress the safety button.

2. With the safety button depressed, pull the bail switch upward to the handle and

release the safety button.

3. Hold the bail switch against the handle with your left hand. Pull the self-propel

trigger to the handle with your right hand.

4. With your right hand, hold both the bail switch and the self-propel trigger against

the handle and use your left hand to adjust the self-propel speed-control lever to

choose the desired speed.

NOTICE: When you turn off the self propel, for example, at the end of a row, it may

become temporarily locked if you pull backwards on the mower. Simply push ahead

slightly and then move the mower as required.

Self-Propel

Trigger

Self-Propel

Speed-Control Lever

Questions and Answers:

Need help?

Do you have a question about the EGO LM2100 and is the answer not in the manual?

EGO LM2100 Specifications

General