To Next Page

To Previous Page

56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC44

REPLACING THE TRAILING SHIELD

WARNING:

Always remove the battery pack when servicing or transporting the

mower.

WARNING:

Never operate the mower unless the trailing shield is in place and

working. Never operate the mower with damaged safety devices. Failure to do so can

result in personal injury. The trailing shield is subject to wear and damage, which could

expose moving parts or allow objects to be thrown. For safety protection, frequently

check the trailing shield and replace it immediately with only the identical replacement

part, listed in this manual.

1. Remove the battery.

2. Turn the mower on its side with

the upper surface against a wall.

3. Remove the rear wheel on the

top side, following the section

“REPLACING THE WHEELS” in this

manual.

4. For self propel mower LM2100SP/

LM2100SP-FC, loosen the wheel

cover locking screw and remove

the screw, spring washer and at

washer in that order, then remove the wheel cover from the wheel shaft (Fig. 34).

Wheel Cover

Locking Screw

Wheel Axle

Questions and Answers:

Need help?

Do you have a question about the EGO LM2100 and is the answer not in the manual?

EGO LM2100 Specifications

General