56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP/LM2100SP-FC/LM2100/LM2100-FC 49
Problem Cause Solution
The mower
stops while
mowing
◾
The battery pack is depleted.
◾
Mower is in overload
condition.
◾
Mower deck is clogged with
grass and debris.
◾
The battery or mower
circuitry is too hot. (The
power indicator on the
mower will illuminate orange
for 10 seconds.)
◾
The side rail is retracted a
little by the pushing force
applying on the handle.
◾
Charge the battery pack.
◾
Raise the cutting height or
slow down the mowing.
◾
Unclog the mower deck.
Raise the cutting height, or
cut a narrow swath.
◾
Allow the battery pack or
mower to cool until the
temperature drops below
152°F (67°C).
◾
Unlock the clamps. Fully
extend the side rails and
lock the clamps again.
The mower
does not
mulch properly
◾
Wet grass clippings are
sticking to the underside of
the deck.
◾
The mower is set to cut too
much grass at once.
◾
Wait until the grass dries
before mowing.
◾
Raise the deck to a higher
cutting height setting.
There is
excessive
vibration
◾
The cutting blade is loose.
◾
The cutting blade is
unbalanced.
◾
The cutting blade is bent.
◾
The motor shaft is bent.
◾
Tighten the blade bolt.
◾
Balance the blade following
the instructions.
◾
Replace the blade.
◾
Contact the service center.
The handle-
locking clamps
cannot be
closed in
position
◾
The side rails are not fully
extended.
◾
Fully extend the side rails,
then lock the clamps.
To Next Page
Loading...
Need help?
General
