56V LITHIUM-ION CORDLESS BRUSHLESS SNOW BLOWER — SNT2100 21
The throwing distance of the snow
blower is adjusted by moving the chute
deector up or down (Fig. 19). Release
the bail switch before adjusting the chute
deector.
1. Squeeze the trigger on the chute
deector handle and move the chute
deector up or down (Fig. 19).
2. Move the chute deector up to
increase the distance the snow will be thrown.
WARNING:
Do not force the chute so far forward that a gap appears between
the deector and the chute itself. Snow or other debris could be thrown through the
gap back at the operator, resulting in serious personal injury.
WARNING:
Do not adjust the chute deector with the bail switch engaged.
Release the bail switch before adjusting the chute deector.
3. Move the chute deector down to decrease the distance the snow will be thrown.
4. Release the trigger to lock the chute deector in place.
CLEARING A CLOGGING CHUTE
WARNING:
Hands coming in contact with the rotating auger inside the chute is
the most common cause of injury associated with snow blowers. Never use your hand
to clean out the chute.
To Clear the Chute:
1. Shut the motor and auger off!
2. Remove the battery packs from the snow blower.
3. Wait 10 seconds to be sure the auger has stopped rotating.
4. Always use a cleanout tool, such as a wood rod or other clearing tools which are
available in supermarket, not your hand.
19
Triggle
Chute
Deector